How to fix a bathroom sink stopper

A bathroom sink stopper can be a source of frustration when it fails to work properly. Whether it is stuck in the closed position, doesn’t hold water, or is stuck in the open position, it can be an inconvenience. Fortunately, fixing a bathroom sink stopper is a relatively easy task that can be accomplished with a few basic tools and a little know-how. In this article, we’ll take you through the steps on how to fix a bathroom sink stopper.

Step 1: Remove the sink stopper

The first step in fixing a bathroom sink stopper is to remove it from the sink. This will give you a chance to inspect the stopper and determine what the problem is. Here’s how to remove the stopper:

  1. Look underneath the sink for the pivot rod that runs from the back of the drain pipe to the back of the sink.

  2. Loosen the nut on the pivot rod and slide it out of the drain pipe.

  3. Lift the stopper out of the drain.

Step 2: Inspect the stopper

Once you have removed the stopper, take a close look at it to determine what the problem is. If the stopper is stuck in the closed position, there may be debris or hair clogging the drain. Clean out any debris or hair that you find. If the stopper is stuck in the open position, it may be due to a broken spring or lever. In this case, you will need to replace the stopper.

Step 3: Clean the stopper

If the stopper is clogged with debris or hair, it’s time to clean it. Here’s how:

  1. Remove any visible hair or debris from the stopper by hand.

  2. Use a toothbrush to scrub the stopper and remove any remaining debris.

  3. Rinse the stopper with water to remove any remaining debris.

Step 4: Clean the drain

With the stopper removed, you have access to the drain. Take this opportunity to clean the drain thoroughly. Here’s how:

  1. Use a flashlight to inspect the drain for debris or hair.

  2. Use a pair of long-handled pliers or a wire hanger to remove any debris or hair that you find.

  3. Pour a mixture of baking soda and vinegar down the drain to help break up any remaining debris.

  4. Run hot water down the drain to flush out any remaining debris.

Step 5: Reinstall the stopper

Once the stopper and drain are clean, it’s time to reinstall the stopper. Here’s how:

  1. Insert the stopper back into the drain.

  2. Slide the pivot rod back into the drain pipe and tighten the nut.

  3. Test the stopper to make sure it is working properly.

If the stopper is still not working properly, you may need to replace it with a new one. Stopper replacement kits can be found at most hardware stores.

In conclusion, fixing a bathroom sink stopper is a relatively simple task that can be accomplished with a few basic tools and a little bit of know-how. By following the steps outlined above, you can easily fix a clogged or stuck sink stopper and restore proper drainage to your bathroom sink.

 

Linear Shower Drain | NDRAIN           SUS304 Shower Niche | NDRAIN

Scroll to Top