How to install a toilet bowl

Installing a toilet bowl may seem like a daunting task, but with the right tools and knowledge, it can be a straightforward process. Whether you’re replacing an old toilet or installing a new one, this guide will walk you through each step to ensure a successful installation.

Step 1: Gather Your Tools and Materials Before you begin, gather all the necessary tools and materials. You’ll need:

  • New toilet bowl
  • Wax ring with flange
  • Toilet bowl bolts
  • Toilet bowl caps
  • Adjustable wrench
  • Screwdriver
  • Putty knife
  • Level
  • Hacksaw or PVC cutter (if needed)

Step 2: Remove the Old Toilet Bowl If you’re replacing an old toilet bowl, start by turning off the water supply to the toilet and flushing it to remove as much water as possible. Then, disconnect the water supply line from the tank and remove the tank itself.

Next, loosen the bolts that secure the toilet bowl to the floor using an adjustable wrench. Once the bolts are loose, carefully rock the toilet bowl back and forth until it comes free. You may need to use a putty knife to break the seal between the toilet and the floor.

Once the toilet bowl is removed, stuff a rag into the drain to prevent any sewer gas from entering your bathroom.

Step 3: Install the Wax Ring and Bolts The wax ring is a critical component of the toilet bowl installation process. It helps create a watertight seal between the toilet bowl and the waste pipe. Start by placing the wax ring onto the flange, which is the circular opening in the floor that connects to the waste pipe.

Next, insert the toilet bowl bolts into the flange, making sure they are evenly spaced and pointing straight up. The bolts should be positioned so that they line up with the holes in the base of the toilet bowl.

Step 4: Position and Secure the Toilet Bowl Carefully lift the toilet bowl and place it onto the wax ring, making sure the bolts fit through the holes in the base of the bowl. Use your body weight to press the bowl firmly onto the wax ring, ensuring a good seal.

Next, secure the toilet bowl to the floor by tightening the bolts with an adjustable wrench. Be careful not to overtighten the bolts, as this can crack the porcelain of the toilet bowl.

Step 5: Install the Toilet Tank If you’re installing a new toilet bowl, you’ll also need to install the tank. Start by attaching the tank to the bowl using the bolts provided. Tighten the bolts by hand, then use a screwdriver to give them a final turn.

Next, attach the water supply line to the fill valve on the bottom of the tank. Turn the water supply back on and allow the tank to fill with water.

Step 6: Test the Toilet Once the tank is full, flush the toilet to ensure everything is working properly. Check for any leaks around the base of the toilet bowl or the tank.

Step 7: Install the Toilet Bowl Caps Finally, install the toilet bowl caps over the bolts to give your toilet a finished look. Simply snap the caps onto the bolts and adjust them as needed to ensure they are level.

And that’s it – you’ve successfully installed a toilet bowl! If you encounter any problems or difficulties during the installation process, don’t hesitate to consult a professional plumber for assistance. With a little bit of know-how and the right tools, you can easily tackle this project and enjoy a fully functioning toilet in no time.

 

Linear Shower Drain | NDRAIN           SUS304 Shower Niche | NDRAIN

Scroll to Top